internal wiring

[homero427]

how's everyone doing?

i finally decided to put my wires through the bars, but don't know where to start. Would i have to cut the wire near the housings or from under the tank? Or just disconnect the wires somehow,damn don't know, all them wires look very thin inside the housings. before i went for it, just wanted an idea how some finished this task. appreciate any advice,,,thanks!!!

[RustyJake]

When I ran my wires I did each side individually. I marked out a drawing of the plug and coded where each wire went. I also took digital pictures (just in case). The wires will come out of the plug, you just need to find an awl or something small and sharp that you can stick in and press down the little retainer. The left side was a pain in the ASS with all the wires. By the end of it, it seemed like I was running out of room. I was able to fish 2-3 wires at a time to start, but quickly had to go to 1 wire at a time. I know there's easier ways, it's just the only way I was confident in doing it.
Takes a lot of time and effort, but the end results are worth it. I'm not too happy about the way the wires enter the bars at the grip ends. But I am a little fussy about shit like that.