Installing Turn SIGS....

[DOUBLED'SSHADOW]

Hey guys.....im getting kinda frustrated......I just got the bolts with the holes in them from kuryan or how ever you spell it .....it says that it fits metric bikes but it doesnt seem like the bolt is thick enough.....plus i cant get the damn wires from the bullet Sigs through the holes......what should i do......

HELP......

Dana :help:

[DOUBLED'SSHADOW]

I wish i would have read some of the post from other people that did the mod because now i just dropped 30 bucks at scoot works to get some hollow bolts that are 10mm instead of 8mm man im pissed.......they should be here in a week....good thing its almost snowing here in cleveland,ohio :madani:

[fegs]

I think someone said that they would not fit. Scootworks do have them. Anyway, the easiest way to get the wires through it is by spraying some WD-40 as this will help them slide through the bolts. But before you go doing that, make sure you have the right bolts. If not, return those and go to www.scootworks.com.

[DOUBLED'SSHADOW]

Hey the turn signals that i bought have two wires comming out of them a red and a black are both wires going to be able to fit through the hollow bolt ???? i tired on the 8mm ones yesterday and couldnt get them through.....but then i realized i had the wrong size bolt so i ordered some 10mm from scoot works.....hope i can get the wires throught them ill be pissed

Dana D........ :smilies23

[AirportFF]

They fit through mine. It's tight but they'll go. Spray a touch of WD40 in the bolt and go slow so you don't mess up the insulation. If the wire already has a connector on it get one about halfway through first then put the other in.

[RustyJake]

I wish i would have read some of the post from other people that did the mod because now i just dropped 30 bucks at scoot works to get some hollow bolts that are 10mm instead of 8mm man im pissed.......they should be here in a week....good thing its almost snowing here in cleveland,ohio :madani:
I'm not going to say I told you so..... :no: But I do recall a thread discussing this very issue. If you can return the Kuryakins, do so. unless you know someone that has 8mm bolts on their fender struts. Hellrisers had the 8mm ones from Kuryakin listed in the spirit section. I had emailed Angela there about it and she wasn't aware they wouldn't fit the Spirit. So she said she removed it as a part for the Spirit.

[AirportFF]

I'm not going to say I told you so..... :no: But I do recall a thread discussing this very issue. If you can return the Kuryakins, do so. unless you know someone that has 8mm bolts on their fender struts. Hellrisers had the 8mm ones from Kuryakin listed in the spirit section. I had emailed Angela there about it and she wasn't aware they wouldn't fit the Spirit. So she said she removed it as a part for the Spirit.


I think it's my fault. I'm the one that suggested the Kuryakyn's....sorry :undecided

[RustyJake]

If he was in Canada, I'd have offered the set I have sitting here. Brand new, still in the vacuum plastic they came in. Obviously with the clearance issues with my back tire, I can't run the wires through the struts.