rear turn signals

[jmaddox]

I moved my rear turn signals to the 2 rear strut mount bolts. I used 2 bolts and drilled the middle of them out. Everything came out great. I was just wondering does anyone sells the bolts predrilled and long enough to pass through the strut.

Jim

[AirportFF]

Try Kuryakyn.com They have some, not sure of the sizes though

[SmokeShowin]

No pics = no turn signals moved to rear strut mount bolts.

[fegs]

I heard that scootworks has them. Try them out.

[jmaddox]

Try Kuryakyn.com They have some, not sure of the sizes though
Thanks found them

[RustyJake]

Don't get the ones from Kuryakin if you own a spirit. They are 8mm x 1.25 thread. The spirit has 10mm x 1.25 threaad on the fender struts. Make sure of your bolt size and thread count if you are putting these on something other then a spirit.
Scootworks is the only place that sells the ones that will work on the spirit.

[AirportFF]

Don't get the ones from Kuryakin if you own a spirit. They are 8mm x 1.25 thread. The spirit has 10mm x 1.25 threaad on the fender struts. Make sure of your bolt size and thread count if you are putting these on something other then a spirit.
Scootworks is the only place that sells the ones that will work on the spirit.


Good point. I mounted hers right thru the fender and not the grabrail. Sorry if I screwed you up Jim.

[jmaddox]

Good point. I mounted hers right thru the fender and not the grabrail. Sorry if I screwed you up Jim.

No I have them bolted through too. Thanks for the info guys

[Joeba]

Good point. I mounted hers right thru the fender and not the grabrail. Sorry if I screwed you up Jim.where did you ground them?Did you drill throught the fender support

[RustyJake]

Most of the new signals that come out only have one wire and no ground. They self ground on the mount itself. If yours has a ground wire, run it to the ground wire the stock signal was using. I believe it's the green wire.

[jmaddox]

where did you ground them?Did you drill throught the fender support

I removed the rear bolt of the fender support. It's probably a hack but I drilled the sub frame out just enough to accept the bolt that I used. I removed the rear fender and support during the install so I could remove the old signal mounts. Just grid down the weld and they come right off clean up the area and repaint.

[Joeba]

thats what i did ,I ounted them to the old turn sig bracket,But i am wondering if the fender support would be a good ground

[Joeba]

I removed the rear bolt of the fender support. It's probably a hack but I drilled the sub frame out just enough to accept the bolt that I used. I removed the rear fender and support during the install so I could remove the old signal mounts. Just grid down the weld and they come right off clean up the area and repaint. cool man thanks

[AirportFF]

where did you ground them?Did you drill throught the fender support

They were the Kurakyn LED's they come with a load equalizer that's grounded so they can operate as running lights and sigs. You just attach the grond wire from the light to that and then into the harness ground wire