olpanrider
08-27-2005, 07:36 PM
In an effort to improve cornering clearances (aka pipes dragging), I removed a 3 inch section of header pipe at the rear cylinder. Rewelded, modified the heat shield, made new bracket and it was done. If ya look at the before and after pics in my garage pics, you'll see the diff. Look at the rear pipe in relation to the rear axle in each pic. When I raised the rear, I then had enough room to adjust the front pipe upward as well. Test run was sucessful and I think that it looks better, but WTF doI know...............see ya.